(1)Parameters:
*Material:Stainless Steel
*Voltage:220V
*Power:150W
*meter
*Length of tail cutter:22.5cm
*Weight:512g
*Application: piglet/swine/sheep/goat tail cutter
(2)Principle and Application:
*The tail cutter has a plier's handle and a jaw, jaw has two rectangular corrugated tooth cutting edge and cross between two upper and lower jaw surface, the cutting edge by the screw connected to the lower jaw side of the blade and the upper jaw with one side of the edge, upper and lower jaw face there are corrugated corrugated teeth, tooth is tooth spacing straight tooth corrugated sine wave is 4-6 mm, corrugated tooth depth is 0.9-1.2 mm, corrugated teeth on the surface of the lower jaw and jaw surface length 40-50 angle, corrugated tooth jaw on the surface of the upper jaw and the length of the same direction.
*Using the tail cutter, hold the cutter handle, let the two upper and lower jaw surface clip on one side of the outer end of the tail, short tail, cutting edge to cut the tail, then cross corrugated pressed in the port at the tail, the tail section of blood vessels, bone, meat, elastic tendon tissue compressed, blocked the tail at the fracture, do not bleed.
(3)Instructions:
- Generally, tail cuttin dose not perform in immune organs, so as to avoid the superposition of stress reaction- To operate at cooler times of the day.- Tail cutting size should be retained tail length 1/3- After tail cutted , please immediately increase the volume of feed and water, helps the animal to heal- Then the tail into the slot after the afterburner to cut tail, the tail to heat the blade incision about a second direction of light pressure
(4)Datails for each parts:
Signup today to claim your Discount. Get Started before it's too late!
