Quick Details
- Processing Time:3
- Port:SHENZHEN
- Supply Ability: 60000 Pieces Per Day
- Technology:Automation
- Resistance Tolerance:Optional
- Resistance:Optional
- Rated Power:Optional
- Operating Temperature:10-85?
- Place of Origin:China
- Model Number:RV24S
- Measuring Range:Optional
- Max. Operating Voltage:220VAC
- Dimensions:Optional
- Brand Name:KC
- Accuracy Class:Optional
- Type:Carbon film
- Brand Name:KC
Features
-24mm diameter, single-turn industrial panel control
-Carbon film element, Linear or audio taper
-SPST switch with 1A,3A or 5A 220VAC rating
-Metal shaft and bushing (Plastic PBT end optional)
-Right angel ear-lay terminals (Left or none optional)
-6mm diameter shafts in slot, flat or round and styles
-Standard 15mm or 20mm shaft length
Precautions for the use of
potentiometers
1.Use chemicals with caution
Potentiometers should avoid exposing the potentiometer to a strong atmosphere of chemicals such as ammonia, amines, alkali solutions,
aromatics, ketones, esters, halocarbons and other chemicals due to the use of synthetic resins such as polycarbonates.
2.Use flux with caution
Water-soluble fluxes should be avoided when soldering, otherwise it will adversely affect the metals and other materials of the
potentiometer
3.Solder
The wiring design and soldering method should avoid causing the melted tin to flow to the upper plane of the PC board, as shown in Figure 1,
which can cause poor contact.
4.Recommended circuit connection
When the potentiometer is used as a variable resistor, it is recommended to be used as a voltage divider to adjust the voltage, and the load
resistance Rl of the potentiometer should not be less than 10 times the nominal resistance of the potentiometer.When the potentiometer is used as a current regulation in a DC circuit, there
will be current through the sliding arm of the potentiometer, which will cause an abnormal increase in the resistance value due to anodic oxidation. In this case, it is recommended to connect
the terminals of the resistor value to the negative pole and the slider arm to the positive pole.
5.Residual resistance
Although the potentiometer resistor is a printed silver layer, in order to improve the reliability of the resistance to vulcanization, a
carbon film is usually covered in the second stage of the resistor, if you want low residual resistance, please contact our company.
6.Condensation
During the use of the potentiometer, the surface of the resistive body should avoid condensation or water droplets, otherwise, it will lead
to a deterioration or short circuit of the insulation resistance.
7.Stress applied to the terminals
Special attention should be paid to avoiding excessive force when holding terminals, and the correct solder conditions should be
designed.
8.Radial shaking of the shaft
When using a shaft with an excessively long length, its radial shaking momentum will be proportional to the shaft length, and the shaft
length should be selected according to actual needs.
9.Installation of the panel
When the potentiometer is mounted with a nut on the panel, too tight will disable the rotational touch function or the thread slip, and the
nut should be locked with great care.
10.Low temperature operation
When the product is used in a low temperature environment, such as a car radio or car audio used in cold areas, the company provides
comfortable products according to customer requirements, please explain when ordering
11.Handle length
The shorter the better the length (at least 5mm) In the case of the width A of the slider, the shorter the length of the handle, the better
the feel, the higher the other force point, the worse the feel.
12.Drive arm
Never keep the operating point away from the slide centerline, for the same reason, the shorter the distance between the two from B, the
better