Hi. I need a high pressure flexible hose (twin-tube) for injecting hydraulic oil or air with the following criteria: 1-The working pressure is 10,000 psi. 2- The ID (Inside Diameter) for a single tube should be 4mm or less. 3- I need two tubes in one hose. I mean, two tubes should properly have been braided together to make one hose. The maximum diameter of the final hose should be 14mm or less. 4- 5*100meter hose (twin-tube). One end of each 100meter tube should be a fitting with 3/8” male NPT thread, and the other end should be a 3/8” female NPT thread. 5- The hose (twin-tube) should be flexible enough to bend around a small pully (about 20 cm diameter). 6- I need a winch or a reel or spool which is rotated by electric power. So, I prefer an electric motor be connected to the middle of the winch or reel or spool and rotate it. The rotation speed should be under control. The electric motor should be able to pull the 1000meter equivalent weight of the hose. We need to be able to easily remove the 100 meter roll and install the new roll on the winch. 7- An extra one meter hose (twin-tube) should be provided with fittings similar to criteria number 4. I hope these are all clear. If you have any question, please ask me. Otherwise please send me the quotation for this order. Show More